LG UD501KOJ5 Owners Manual - Page 13

Using the Pump

Get LG UD501KOJ5 PDF manuals and user guides View all LG UD501KOJ5 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 13 highlights

ENGLISH 12 OPERATION ! NOTE • If the water bucket is removed immediately after turning off the dehumidifier, the water remaining in the heat exchanger may drip inside the water bucket storage area. Remove the water with a soft cloth. • While cleaning, do not touch the water detection device on the inside top of the water bucket storage area. • Clean the water bucket once a week during use. • If the ambient temperature is low, there is less moisture in the air for the product to remove. • Unplug the product before removing the water bucket. If the bucket is removed while the product is operating, the compressor stops. The fan operates for another three minutes to clear the remaining water inside the heat exchanger and then also stops. ! CAUTION Watch pinch points to avoid injuring fingers when installing the water bucket. 2 Insert the adapter on one end of the included long pump hose into the pump hose connector until it stops. Gently tug on the hose to make sure the hose is secure. Push hose in 3 Place the end of the long pump hose in a nearby sink or drain. Secure the hose in place to prevent it from falling out of the ! sink. Using the Pump The pump function provides continuous drainage which can be enabled from the control panel. 1 Unplug the product. Turn the hose cover at the back of the product counterclockwise to open it and reveal the pump hose connector.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
12
OPERATION
ENGLISH
2
Insert the adapter on one end of the
included long pump hose into the pump
hose connector until it stops. Gently tug on
the hose to make sure the hose is secure.
3
Place the end of the long pump hose in a
nearby sink or drain. Secure the hose in
place to prevent it from falling out of the
sink.
Watch pinch points to avoid injuring
fingers when installing the water bucket.
CAUTION
!
NOTE
!
• If the water bucket is removed
immediately after turning off the
dehumidifier, the water remaining in the
heat exchanger may drip inside the water
bucket storage area. Remove the water
with a soft cloth.
• While cleaning, do not touch the water
detection device on the inside top of the
water bucket storage area.
• Clean the water bucket once a week
during use.
• If the ambient temperature is low, there is
less moisture in the air for the product to
remove.
• Unplug the product before removing the
water bucket. If the bucket is removed
while the product is operating, the
compressor stops. The fan operates for
another three minutes to clear the
remaining water inside the heat
exchanger and then also stops.
Push hose in
!
Using the Pump
The pump function provides continuous
drainage which can be enabled from the
control panel.
1
Unplug the product. Turn the hose cover at
the back of the product counterclockwise to
open it and reveal the pump hose
connector.