LG WM2688HNM Owners Manual - Page 7

• Electrical connection • Do not use an extension cord or double adapter. • If the supply cord is damaged, it must be replaced by a qualified person in order to avoid a hazard. • If the machine will not be used for an extended time, unplug it and shut off the water supply. • Connect the machine to a grounded outlet in accordance with current wiring regulations. • The appliance must be positioned so that the plug is easily accessible. • Connecting water supply hose Hot Cold water tap Sealing • Water supply pressure must be between 14.5 and 116 PSI (100N800 kPa). • Do not crossthread when connecting inlet hose to the valve. • If the water supply pressure is more than 116 PSI, a pressure reducing device should be installed. • Two Sealing washers are supplied with the water inlet hoses to prevent water leaks. • Check for leakage of washing machine connections by turning the tap completely on. • Periodically check the condition of the hose and replace the hose if necessary. • Make sure that there is no kink in the hose and that it is not crushed. • Be sure that the two water input ports are connected to the correct water faucets. The connector for hot water is colored red. NOTE: Washing Machine is to be connected to the water mains using new hoses. Old hoses should not be used. Repairs to the washing machine must only be carried out by qualified personnel. Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. Contact your local service center. Do not install yore" washing machine in a room where temperatures below freezing may occur. Frozen hoses may bm'st under pressure. The reliability of the electronic control unit may be impaired at temperatures below the freezing point. If the appliance is delivered in the winter months and temperatures are below freezing, store the washing machine at room temperatm'e for a few hours before putting it into operation. 7