LG WM3477HW User Guide - Page 32
Problem, Possible Causes, Solutions - error codes
View all LG WM3477HW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
TROUBLESHOOTING BEFORE CALLING FOR SERVICE (cont.) Problem Wrinkling Drum light does not stay on The display shows: The display shows: Possible Causes Solutions • Washer not unloaded promptly. • Washer overloaded. • Hot and cold water inlet hoses are reversed. • Always remove items from the washer as soon as the cycle is completed. • The washer can be fully loaded, but the drum should not be tightly packed with items. The door of the washer should close easily. • Hot water rinse can set wrinkles in garments. Check the inlet hose connections. • This is normal. • The drum light shuts off automatically when the washer starts. Press and hold the RINSE+SPIN button for 3 seconds to turn on the light; it will turn off automatically after 4 minutes. • Load is too small. • Load is out of balance. • The washer has an imbalance detection and correction system. If individual heavy articles are loaded (bath mat, bath robe, etc.) and the imbalance is too great, the washer will make several attempts to restart the spin cycle. If an imbalance is still detected, the washer will stop and the error code will be displayed. • Control error. • Add 1 or 2 similar items to help balance the load. • Rearrange items to help balance the load. • Unplug the washer and call for service. The display shows: • Water level is too high due to a faulty water valve. • Close the water taps, unplug the washer, and call for service. The display shows: • The water level sensor is not working correctly. • Close the water taps, unplug the washer, and call for service. The display shows: The display shows: • Thermal overload protection circuit in the motor has been tripped. • A power failure has occurred. • Allow the washer to stand for 30 minutes to allow the motor to cool; then restart the cycle. If the LE error code still appears, unplug the washer and call for service. • Restart the cycle. The display shows: • Check water supply. • Turn the tap on. If " " is not released, unplug power plug and call for service. 32