LG XBV713 Operation Guide - Page 16

AUDIO Each DVD disc has a variety of audio output options. Set the player's AUDIO options according to the type of audio system you use. AUDIO Dolby Digital DTS MPEG Sample Freq. DRC Vocal Bitstream Bitstream PCM 48 kHz LOCK (Parental Control) LOCK Rating Password Area Unlock New US Move On Off Select Rating Move Select Blocks playback of rated DVDs based on their content. Not all discs are rated. 1. Select "Rating" on the LOCK menu then press B. 2. To access the LOCK options, you must input the password you have created. If you have not yet entered password, you are prompted to do so. Input a password and press ENTER (OK). Enter it again and press ENTER (OK) to verify. If you make a mistake before pressing ENTER (OK), press CLEAR. 3. Select a rating from 1 to 8 using the v / V buttons. Rating 1-8: Rating one (1) has the most restrictions and rating eight (8) is the least restrictive. Unlock: If you select unlock, parental control is not active and the disc plays in full. 4. Press ENTER (OK) to confirm your rating selection, then press SETUP/MENU to exit the menu. Password You can enter or change password. 1. Select Password on the LOCK menu then press B. 2. Follow step 2 as shown above (Rating). To change the password, press ENTER (OK) when the "Change" option is highlighted. Input a password and press ENTER (OK). Enter it again and press ENTER (OK) to verify. 3. Press SETUP/MENU to exit the menu. If you forget your password If you forget your password, you can clear it using the following steps: 1. Press SETUP/MENU to display the Setup menu. 2. Input the 6-digit number "210499". The password is cleared. Dolby Digital / DTS / MPEG Bitstream - Select "Bitstream" if you connect this DVD player's DIGITAL OUT jack to an amplifier or other equipment with a Dolby Digital, DTS or MPEG decoder. PCM (for Dolby Digital / MPEG) - Select when connected to a two-channel digital stereo amplifier. DVDs encoded in Dolby Digital or MPEG will be automatically downmixed to two-channel PCM audio. Off (for DTS): If you select "Off", the DTS signal is not output through the DIGITAL OUT jack. Sample Freq. (Frequency) If your receiver or amplifier is NOT capable of handling 96 kHz signals, select 48 kHz. When this choice is made, this unit automatically converts any 96 kHz signals to 48 kHz so your system can decode them. If your receiver or amplifier is capable of handling 96 kHz signals, select 96 kHz. Check the documentation for your amplifier to verify its capabilities. Dynamic Range Control (DRC) With the DVD format, you can hear a program's soundtrack in the most accurate and realistic presentation. However, you may wish to compress the dynamic range of the audio output (the difference between the loudest sounds and the quietest ones). This allows you to listen to a movie at a lower volume without losing clarity of sound. Set DRC to On for this effect. Vocal Set to On only when a multi-channel karaoke DVD is playing. The karaoke channels on the disc mix into normal stereo sound. 16