Lenovo 821532U User Manual - Page 73
procedures on Remove USB devices and re-test
UPC - 882861093526
View all Lenovo 821532U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
Diagnostic Error Code 014-03X-XXX 014-04X-XXX Parallel port failure 014-195-XXX Parallel port Test aborted by user 014-196-XXX Parallel port test halt, error threshold exceeded 014-197-XXX Parallel port test warning 014-198-XXX Parallel port test aborted 014-199-XXX Parallel port test failed, cause unknown 014-2XX-XXX 014-3XX-XXX Parallel port failure 015-000-XXX USB port Interface Test Passed 015-001-XXX USB port Presence 015-002-XXX USB port Timeout 015-015-XXX USB port External Loopback failure 015-027-XXX USB port Configuration/Setup error 015-032-XXX USB port Device Controller failure FRU/Action System board Information only Re-start the test, if necessary 1. Press F3 to review the log file 2. Re-start the test to reset the log file 1. Make sure the component that is called out is connected and/or enabled. See Chapter 6, "Using the Setup Utility," on page 53 2. Re-run test 3. Replace the component that is called out in warning statement 4. Replace the component under test 1. If a component is called out, make sure it is connected and/or enabled 2. Flash the system and re-test. See "Flash update procedures" on page 516 3. Go to "Undetermined problems" on page 88 1. Go to "Undetermined problems" on page 88 2. Flash the system and re-test. See "Flash update procedures" on page 516 3. Replace component under function test 1. External parallel device 2. System board No action 1. Remove USB device(s) and re-test 2. System board 1. Remove USB device(s) and re-test 2. System board 1. Remove USB device(s) and re-test 2. System board 1. Flash the system. See "Flash update procedures" on page 516 2. System board System board Chapter 7. Symptom-to-FRU Index 67