Lenovo H405 Lenovo H4 Series Hardware Replacement Guide V1.0 - Page 17
Replacing a memory module
View all Lenovo H405 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Replacing a memory module Attention: Do not remove the computer cover or attempt any repair before reading the "Important safety information" in the Safety and Warranty Guide that was included with your computer or in the Hardware Maintenance Manual (HMM) for the computer. To obtain copies of the Safety and Warranty Guide or HMM, go to the Support Web site at http://consumersupport.lenovo.com To replace a memory module: 1. Remove the computer cover. Refer to "Removing the computer cover". Note: For this procedure, it helps to lay the computer on its side. 2. Locate the memory module connectors. Refer to "Locating components". 3. Remove the memory module being replaced by opening the retaining clips as shown. 4. Position the new memory module over the memory connector. Make sure the notch on the memory aligns correctly with the connector key on the system board. Push the memory module straight down into the connector until the retaining clips close. 14 Hardware Replacement Guide 31045292_H4_HRG_EN_V1.0.indd 14 2010.9.19 11:11:22 AM