Lenovo ThinkPad T530 Hardware Maintenance Manual - Page 46
Numeric error codes, Enter ThinkPad Setup. - The checksum of the Security - cmos battery
View all Lenovo ThinkPad T530 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Numeric error codes Table 1. Numeric error codes Symptom or error FRU or action, in sequence 0177: Bad SVP data, stop POST task. - The checksum System board of the supervisor password in the EEPROM is not correct. 0183: Bad CRC of Security Settings in EFI Variable. Enter ThinkPad Setup. - The checksum of the Security settings in the EFI Variable is not correct. Enter ThinkPad Setup to correct Security settings in the EFI Variable. 0187: EAIA data access error. System board 0188: Invalid RFID Serialization Information Area. - The System board EEPROM checksum is not correct (Block #0,1). 0189: Invalid RFID configuration Information Area. - The System board EEPROM checksum is not correct (Block #4,5). 0190: Critical low-battery error • Charge the battery pack. • Battery pack 0191: System Security - Invalid Remote Change requested. • Run ThinkPad Setup, and then save the current setting by pressing F10. • System board 0199: System Security - Security password retry count exceeded. • Run ThinkPad Setup, and then save the current setting by pressing F10. • System board 0251: System CMOS checksum bad - Default configuration used 1. Charge the backup battery for more than 8 hours by connecting the ac adapter. 2. Replace the backup battery and run ThinkPad Setup to reset the time and date. 0253: EFI Variable Block Data was destroyed. 0271: Real-Time Clock Error. Check Date and Time settings. Run ThinkPad Setup to reset the time and date. 1802: Unauthorized network card is plugged in - Power off and remove the mini PCI network card. • Remove Mini PCI network card. • System board 1820: More than one external fingerprint reader is attached. Power off and remove all but the reader that you set up within your main operating system. Remove all but the reader that you set up for the authentication. 2000: ThinkVantage® Active Protection sensor diagnostics System board failed. 2100: Detection error on HDD0 (Main HDD) 1. Reseat the hard disk drive. 2. Main hard disk drive 3. System board 2101: Detection error on HDD1 (Ultrabay HDD) 1. Reseat the hard disk drive. 2. Ultrabay® hard disk drive 3. System board 2102: Detection error on HDD2 (Mini SATA) 1. Reseat the Mini SATA device. 2. Mini SATA device 3. System board 2110: Read error on HDD0 (Main HDD) 1. Reseat the hard disk drive. 2. Main hard disk drive 3. System board 40 Hardware Maintenance Manual