Lexmark 20G0130 User's Guide - Page 13
Installing drivers for local printing, Setting parameters in the printer, Reports, Menu Settings
UPC - 734646721325
View all Lexmark 20G0130 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Installing drivers for local printing Before you can print, you must establish communication between the printer and computer. To do this: 1 Set serial parameters in the printer. 2 Install a printer driver on the attached computer. 3 Match the serial settings in the COM port. Setting parameters in the printer 1 Press on the operator panel. 2 Press until Reports appears, and then press . Note: For information about serial menus and messages, see the publications CD that shipped with the printer. 3 Press until Menu Settings Page appears, and then press . The printer returns to Ready. 4 Press . 5 Press until Network/Ports appears, and then press . 6 Press until Serial Standard or Serial Option X appears, and then press . (x) is the number of the serial port. 7 Press until press . appears (where is the parameter required for a change), and then 8 Press until appears (where is the setting required for a change), and then press . Note the following restrictions: • Maximum baud rate supported is 115,200. • Data Bits must be set to 7 or 8. • Parity must be set to Even, Odd, or None. • Stop Bits must be set to 2. • Flow Control recommended protocol setting is Xon/Xoff. 9 Press . The printer returns to Serial or Serial x. 10 Print a Menu Settings page, and verify the serial parameters are correct. Note: Keep this page for later use. a Press on the operator panel. b Press until Reports appears, and then press . c Press until Menu Settings Page appears, and then press . d Look under the Standard Serial (or Serial Option X if a serial interface card is installed) heading to find the serial parameters. Windows 13