Lexmark 852e Clearing Jams Guide - Page 3

231 Jam 1 Open Door D by the duplex rear door. 5 Pull the print media up. Warning: If the print media does not move immediately when you pull, stop pulling. Pull the green lever to make it easier to remove the media. Make sure all paper fragments are removed. 2 Remove the media from the MFP tray slot. 2 Remove the jammed media. D 3 Close Door D. 4 Open Door A by pushing the release latch and lowering the door. 6 Close Door A. 7 Touch Continue. 24x Jams Paper jams in these areas can occur on the incline surface of a tray or across more than one tray. To clear these areas: 1 Open the tray. If necessary, remove the tray from the MFP. 3 Remove any crumpled paper from the tray. 4 Insert the tray into the MFP. 5 Touch Continue. 250 Jam 1 Remove the paper from the multipurpose feeder. 2 Flex, fan, and restack the media, and place it into the multipurpose feeder. 3 Load the print media. 4 Slide the side guide toward the inside of the tray until it lightly rests against the edge of the media. 5 Touch Continue. CAUTION: The inside of the MFP might be hot.