Lexmark 854e Menus and Messages Guide - Page 109

Attendance messages Message 290.21 Scanner jam, remove all originals from the scanner 290.22 Scanner jam, remove all originals from the scanner 290.23 Scanner jam, remove all originals from the scanner 290.90 Scanner jam, remove all originals from the scanner 291.00 Scanner jam, remove all originals from the scanner 291.01 Scanner jam, remove all originals from the scanner 291.02 Scanner jam, remove all originals from the scanner 291.03 Scanner jam, remove all originals from the scanner 293 Replace all originals if restarting job. 294.00 Scanner jam, remove all originals from the scanner 294.01 Scanner jam, remove all originals from the scanner Meaning Action The scanner detects a jam at the ADF Remove all original documents from the size sensor 1 while the scanner is scanner to clear the jam. The message clears. idle. The scanner detects a jam at the ADF Remove all original documents from the size sensor 2 while the scanner is scanner to clear the jam. The message clears. idle. The scanner detects a jam at the ADF Remove all original documents from the size sensor 3 while the scanner is scanner to clear the jam. The message clears. idle. The scanner detects a jam at the feed Remove all original documents from the motor. scanner to clear the jam. The message clears. The scanner detects a jam at the ADF Remove all original documents from the registration sensor while the scanner scanner to clear the jam. The message clears. is idle. There is a jam in the scanner which occurred while the original document was being inverted in the ADF, but the invert sensor is turned off. Remove all original documents from the scanner to clear the jam. The message clears. The scanner detects a jam while inverting the original document in the ADF, and the invert sensor is turned on. Remove all original documents from the scanner to clear the jam. The message clears. There is a jam in the ADF, but the invert sensor is turned off. Remove all original documents from the scanner to clear the jam. The message clears. The MFP is sent a scan job; however, there is no original document in the ADF. Touch Continue if no scan job is active when the attendance message appears. This clears the message. Touch Cancel Job if a scan job is processing when the attendance message appears. This cancels the job and clears the message. Touch Scan from Automatic Document Feeder if the page jam recovery is active. Scanning resumes from the ADF immediately after the last successfully scanned page. Touch Scan from flatbed if page jam recovery is active. Scanning resumes from the flatbed immediately after the last successfully scanned page. Touch Finish job without further scanning if page jam recovery is active. The job ends at the last successfully scanned page, but the job is not canceled. Successfully scanned pages go to their destination: copy, fax, e-mail, or FTP. Touch Restart job if job recovery is active and the job is restartable. The message clears. A new scan job containing the same parameters as the previous job starts. The scanner detects a jam at the ADF Remove all original documents from the invert sensor while the scanner is idle. scanner to clear the jam. The message clears. The scanner detects a jam in the ADF when the pre-registration sensor is on to recognize the scan of side (page) 2 of a sheet. Remove all original documents from the scanner to clear the jam. The message clears. 109