Lexmark T630 User's Reference - Page 111
Solving printing problems, Problem, Action - tray problems for windows 7
UPC - 734646385756
View all Lexmark T630 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 111 highlights
Solving printing problems Problem Action Job did not print or incorrect If you are using a print spooler, verify that the spooler is not stalled. characters printed (continued). If you print across a network or on a Macintosh computer, see Solving network printing problems. Check the printer interface from the Setup Menu. Determine which host interface you are using. Print a menu settings page to verify that the current interface settings are correct. See Solving network printing problems. If you are using a serial interface: • Make sure Honor DSR is set to Off. • Check the protocol, baud, parity, and data bit settings. The settings on the printer and on the host computer should match. Printer is connected to the Make sure you are using Windows 98, Windows 2000, Windows Me, USB port, but will not print. or another USB-capable operating system supported by Lexmark. Print media misfeeds or multiple feeds occur. Envelope misfeeds or multiple feeds occur. Page breaks in unexpected places. Make sure the print media you are using meets the specifications for your printer. See Identifying print media sources and specifications for more details. Flex print media before loading it in any of the sources. Make sure the print media is loaded correctly. Make sure the width and length guides on the print media sources are adjusted correctly. Do not overfill the print media sources. Do not force print media into the multipurpose feeder when you load it; otherwise, it may skew or buckle. Remove any curled print media from sources. Load the recommended print side correctly for the type of print media you are using. See Loading print media in standard and optional trays for more information. Load less print media in the sources. Turn the print media over or around and try printing again to see if feeding improves. Do not mix print media types. Do not mix reams of print media. Remove the top and bottom sheets of a ream before loading the print media. Load a print media source only when it is empty. Remove the stack of envelopes from the envelope feeder. Load one envelope, feed it through the printer, and then reload the stack of envelopes in the envelope feeder. Check the Print Timeout setting in the Setup Menu. Increase the setting. 111