Lexmark T650DN Service Manual - Page 113

4062 Error code or message 28x.51 x = bin number Error contents Right tamper home position jam Applies to: StapleSmart finisher 28x.52 x = bin number 28x.53 x = bin number 28x.54 x = bin number 28x.55 x = bin number 28x.56 x = bin number 28x.57 x = bin number Paddle control motor timer error Applies to: StapleSmart finisher Eject motor encoder not detected Applies to: StapleSmart finisher Eject motor encoder not detected Applies to: StapleSmart finisher Eject motor overspeed failure Applies to: StapleSmart finisher Eject motor underspeed failure Applies to: StapleSmart finisher Sensor (stapler pass through) static jam Applies to: StapleSmart finisher Description/Action Possible repair actions The right tamper home position is not detected by the sensor (right tamper HP) A software failure has occurred with the output option. 1. Check all the connections on the output option controller card. 2. Check the tamper drive belt for damage and replace if needed. 3. Replace the right tamper motor assembly. Go to "SFP stapler assembly tamper drive motor assembly removal" on page 4-180. 4. Replace the sensor (tamper HP). Go to "SFP stapler assembly sensor (tamper HP left and right) removal" on page 4-187. 4. Replace the output option if problem remains. 1. Turn the machine off/on. 2. Replace the output option if problem remains. The eject motor encoder is not detected upon startup The eject motor encoder detection is lost during normal operation. The eject motor rotate at the specified speed The eject motor rotate at the specified speed Media remains on the sensor (stapler pass through) during the warm up sequence. 1. Check all the connections on the output option controller card. 2. Replace the output option if problem remains. 1. Check all the connections on the output option controller card. 2. Replace the output option if problem remains. 1. Check all the connections on the output option controller card. 2. Replace the output option if problem remains. 1. Check all the connections on the output option controller card. 2. Replace the output option if problem remains. Go to sensor (stapler pass through) static jam service check. See "Sensor (stapler pass through) static jam service check" on page 2-149. Diagnostic information 2-79