Lexmark X464de Service Manual - Page 53
Select, User primary message, Explanation, Restore Held Jobs. Go - user guide
View all Lexmark X464de manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
7014-xxx User status and attendance messages (Continued) User primary message Explanation Load Manual Printer does not detect media meeting the description and in the single sheet feeder (manual feeder). The following actions can be taken: • Load paper and the job continues. • press Select ( ), and choose an alternate source for media. • Cancel the current job. Paper Changes Needed Change or load new media. PJL OP Message PJL Seed Message PJL ST Message Try one or more of the following: • press Select ( ) to clear the message, and continue printing. • Wait for the message to clear. Remove Paper ADF This posts when there is paper detected in the ADF upon POR or when the cover is closed (or any other situation that re-inits the scanner). Message clears when paper is removed. Remove Paper Standard Bin The standard output bin is full or nearly full. Remove the media from the bin. Restore Held Jobs. Go/ Stop? Held jobs were found on disk after a power on/off reset. Restoring will make these jobs available. Jobs may also be restored at a later time by turning off and restarting the printer. The following actions can be taken: • Restore • Do not restore • More information Securly Clearing Disk Space This message appears when all blocks of the disk are cleared. Unsupported USB Remove the unrecognized device from the USB port on the front of the printer. Device, Please Remove Unsupported USB Hub, Remove the unrecognized USB hub/device from the USB port on the front of the please remove printer. Unsupported Disk 34 Short Paper Remove the unsupported disk before continuing. • press Select ( ) to clear the message and continue printing. The printer does not automatically reprint the page that prompted the message. • Check tray length and width guides to ensure paper is properly fitted in the tray. • Make sure the print job is requesting the correct size of paper. • Adjust the Paper Size setting for the size paper you are using. If MP Feeder Size is set to Universal, make sure the paper is large enough for the formatted data. • Cancel the current job. Diagnostics information 2-15