LiftMaster 3950 3950 Manual - Page 11
INSTALLING THE BRACKETS, Wall installation s 1 and 2, Floor installation
View all LiftMaster 3950 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
INSTALLING THE BRACKETS Be sure power to the operator is disconnected. Install and align the brackets so the safety reversing sensors will face each other across the door, with the beam no higher than 6" (15 cm) above the floor. They may be installed in one of three ways, as follows. Wall installation (Figures 1 and 2): • Place the bracket against the wall with curved arms facing the door. Be sure there is enough clearance for the sensor beam to be unobstructed. • If additional depth is needed, an extension bracket (see accessories) or wood blocks can be used. • Use bracket mounting holes as a template to locate and drill (2) 3/16" diameter pilot holes on the wall at each side of the door, no higher than 6" (15 cm) above the floor. • Attach brackets to wall with lag screws (Not provided). • If using extension brackets or wood blocks, adjust right and left assemblies to the same distance out from the mounting surface. Make sure all door hardware obstructions are cleared. Floor installation (Figure 3): • Use wood blocks or extension brackets (see accessories) to elevate sensor brackets so the lenses will be no higher than 6" (15 cm) above the floor. • Carefully measure and place right and left assemblies at the same distance out from the wall. Be sure all door hardware obstructions are cleared. • Fasten to the floor with concrete anchors as shown. Figure 1 IWnsaildl e WALL MOUNT (RIGHT SIDE) Fasten Wood Block to Wall with Lag Screws (Not Provided) Indicator Light Sensor Bracket Lag Screws (Not Provided) Lens Figure 2 IWnsaildl e WALL MOUNT (RIGHT SIDE) Extension Bracket (See Accessories) (Provided with Extension Bracket) (Provided with Extension Bracket) Sensor Bracket Indicator Lens Light Figure 3 FLOOR MOUNT (RIGHT SIDE) IWnsaildle Lens Attach with Concrete Anchors (Not Provided) Indicator Light Sensor Bracket 11