LiftMaster 8160 8160 Users Guide Manual - Page 6
Using the Door Control, Programming - Push Button Door, Control
View all LiftMaster 8160 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Operation Using the Door Control SYNCHRONIZE THE DOOR CONTROL To synchronize the door control to the garage door opener, press the push bar or push button until the garage door opener activates (it may take up to 3 presses). Test the door control by pressing the push bar or push button, each press of the push bar or push button will activate the garage door opener. Push Bar SERVICE LED LEARN Button LOCK Button COMMAND LED LIGHT Button LOCK The LOCK feature is designed to prevent activation of the garage door opener from remote controls while still allowing activation from the door control and keyless entry. This feature is useful for added peace of mind when the home is empty (i.e. vacation). AUTOMATIC LIGHT Light Feature The lights will turn on when someone enters through the open garage door and the safety reversing sensor infrared beam is broken. MAINTENANCE ALERT SYSTEM (MAS) This feature assists the homeowner in ensuring the garage door opener system stays in good working condition. When the garage door opener needs to be serviced (approximately 4500 garage door opener cycles) the command (yellow) and service (red) LEDs will begin to alternately flash back and forth. The factory setting for the MAS feature is off and can be activated at time of installation. Contact your installing dealer for service. Programming - Push Button Door Control Push Button Light Button Push Button Light Button PUSH BAR OR PUSH BUTTON Press the push bar or push button to open or close the door. LIGHT BUTTON Press the LIGHT button to turn the garage door opener lights on or off. When the lights are turned on they will stay on until the LIGHT button is pressed again, or until the garage door opener is activated. Once the garage door opener is activated the lights will turn off after the specified period of time (the factory setting is 4-1/2 minutes). The LIGHT button will not control the lights when the door is in motion. The following features are accessible by lifting the push bar (multi-function door control only): LEARN A DEVICE Any compatible remote controls or wireless keyless entries can be programmed to the garage door opener by pressing the LEARN button on the Multi-Function Control Panel. Feature To Program 1. Press and hold the Light button and a Remote the Push button until the Push button Control or Keyless Entry LED begins to blink. 2. Remote Control: Press the button on the remote control that you wish to operate your garage door. Keyless Entry: Enter a 4-digit personal identification number (PIN) of your choice on the keyless entry keypad. Then press the ENTER button. The garage door opener lights will flash (or two clicks will be heard) when the code has been programmed. 6