Linksys EG0801SK User Guide - Page 21

Instant Gigabit Series 5. Highlight the Linksys EG1032/EG1064 Instant Gigabit Network Adapter entry in the window that appears. Click OK. EtherFast® 10/100/1000 8+1 Workgroup GigaSwitch Starter Kit 8. Click on the Protocols tab. Add any protocols you require by clicking the Add button. (Refer to your Microsoft documentation if you have any questions on adding protocols.) 9. After your bindings, settings, and services are set, click the Close button. 10. Remove your Driver Disk and CD-ROM and click Yes to restart your PC. 6. Windows NT then asks you for the media type. Choose the AutoSense option. When finished, click on OK. Click Close. 7. NT will probably ask you to supply your original Windows NT CD-ROM or setup disks. Direct Windows NT to the proper location (most likely D:\i386). 35 11. Once your PC has rebooted, double-click the Network Neighborhood icon on your desktop. Ensure that you have access to the network. If you do, your card has been properly installed. • If you had previously installed a NT service pack, you must re-install that now. Otherwise, you may receive Not Enough Service Storage Space errors in the Event Viewer. • If you need to install the TCP/IP protocol, refer to your system administrator or your Windows NT documentation. Linksys does not provide technical support for the configuration or troubleshooting of the TCP/IP protocol The Windows NT Installation and Setup of the Instant Gigabit Network Adapter is complete Note: If you had previously installed an NT service pack, you must reinstalll it now.Otherwise, you may receive Not Enough Service Storage Space errors in the Event Viewer. 36