Linksys FENSK05-CA User Guide - Page 16
Windows 2000 Installation &, Setup
UPC - 745883549658
View all Linksys FENSK05-CA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Linksys EtherFast® Series Windows 2000 Installation & Setup Overview After physically installing the EtherFast 10/100 LAN Card in your computer, follow these instructions to install the network driver. The installation procedure for the network driver will vary slightly depending on which version of Windows 2000 you are using, and on your current system configuration. Note: Prior to proceeding, ensure that you are operating Windows 2000 with administrative rights. If you log into Windows 2000 without administrative rights, you may run into problems during the installation. Installing the Driver in Windows 2000 After physically installing the EtherFast Card in your computer, follow these instructions to install the network driver. 1. Start your computer if you haven't already done so, and boot Windows 2000. Log in with administrative rights if you are asked to. 2. Windows will display the Found New Hardware Wizard box. Click Next. 10/100 Network In a Box 3. The Install Hardware Device Drivers dialog box will appear. When Ethernet Controller is displayed, select "Search for a suitable driver for your device (Recommended)". Click Next. 4. The Locate Driver Files dialog box will appear. Select "Specify a location". Click Next. 26 27