Magnavox 14MS2331 User manual, English (US) - Page 6

2 Cable Box Connections If you cable signal uses a cable box or decoder, follow the easy steps below to complete the connection. Cable Box (w/RF In/Outputs): This connection will be mono. 1 Connect the Cable Company supplied cable to the signal IN(put) plug on the back of the Cable Box. 2 Using a separate round coaxial cable, connect one end to the OUT(put) (TO TV) plug on the back of the Cable Box. 3 Connect the other end of the round coaxial cable to the 75Ω input on the back of the television. Screw it down finger tight. NOTE: If applicable, set the OUTPUT CHANNEL SWITCH on the back of the cable box to CH 3 or 4. Tune the TV to the same channel and change channels at the cable box. In some cases, the cable box will automatically tune to either channel 3 or 4, change channels until the picture appears. Cable Signal IN from the Cable Company 2 TO TV/VCR CABLE IN 1 IR USB VIDEO AUDIO IN SPDIF IN OUT R L DVD-D OUT S-VIDEO AUDIO OUT Y Pb Pr TV PASSCARD OPTICAL SPDIF Jack Panel Back of Cable Box 3 75Ω Round 75Ω Coaxial Cable 75Ω Jack Panel Back of TV Helpful Hints If no Video Signal is present, the TV will shut itself off in about 10 minutes. If the TV is tuned to the AV channel and there is no Video Signal present, the screen will remain black and the TV will shut itself off in about 10 minutes.