Magnavox 20MC4204 User manual, English - Page 11

20MC4204 04.2.25 9:33 PM Page 11 First-Time Setup,Watching TV 11 These SET UP screens will appear the first time you turn on the TV/DVD. Set the language for the menus and have the unit memorize available TV channels. If you are using a Cable Box or Satellite Receiver, do not set 1 channels at the TV/DVD. Set it to the output channel of the 4 Cable Box/Satellite Receiver (channel 3, 4, or AUX). Select channels at the Cable Box/Satellite Receiver. See page eight. 5 1 Press STANDBY-ON to turn on the TV/DVD. 2 Press ENTER repeatedly to select ENGLISH, ESPAÑOL, or FRANÇAIS. The selected language will appear inside the [ ].This will be the language of the TV/DVD menus. 2-3 - SET UP - B LANGUAGE [ENGLISH] ESP FRA AUTO PRESET 3 Press ▲ or ▼ to select AUTO PRESET.Then press ENTER. The menu will disappear and the TV/DVD will start scanning channels. Active channels will be memorized during this process. When scanning is complete, the TV/DVD will go to the lowest available channel automatically. - SET UP - LANGUAGE [ENGLISH] ESP FRA B AUTO PRESET 4 To watch TV, press the CH. ▲ or ▼ buttons to select memorized channels.These appear automatically when you flip through channels. If a channel is skipped, use the Number buttons to select it.This is a nonmemorized channel; it may have weak reception in your area. Remember, if you are using a Cable Box/Satellite Receiver, set the TV/DVD to channel 3 or 4 or AUX. Change channels at the Cable Box/Satellite Receiver. 5 Press VOL. ▲ or ▼ to adjust the volume. VOLUME 20 Helpful Hints • If the power fails, you may need to repeat this first-time setup. • You may not see these menus when you turn on the TV/DVD. Set channels and the menu language later. See page 17. • To select Cable TV channels above 99, press the +100/+10 button, then press the Number buttons for the last two digits. For example, to select channel 125, press +100/+10, 2, 5. Precede single-digit channel numbers with a zero (for example, 01 ... 09). • Pressing CH. ▲ or ▼ in DVD mode puts the unit in TV mode. • If you turn off the unit in DVD mode, when you turn it on again, it will be in TV mode. • To remove the SET UP menu or stop scanning channels, press SETUP on the remote.