Magnavox 20MF500T Quick Start Guide - Page 5

TUNER MODE CONTROL The Tuner Mode allows you to change the LCD TV's signal input to Cable or Air (antenna). It's important for the LCD TV to know if you want to receive channels from a cable TV signal or an antenna signal. 1 Press the Menu MENU button to see the onscreen menu. 2 Press the (CH-) button to highlight the INSTALL menu. 3 Press the (VOL+) button to enter the INSTALL menu. 4 Press the (CH-) button to highlight the TUNER MODE menu. 5 Press the (VOL+) or AUTO. or (VOL-) buttons to select CABLE, ANTENNA 6 Press the MENU MENU button repeatedly to clear the menu from the screen. HELPFUL HINT • When CABLE is selected, channels 1-125 are available. • When ANTENNA is selected, channels 2-69 are available. • When AUTO is selected, your LCD TV will search automatically for antenna or cable channels. • Immediately after unpacking and plugging in your new television, run the AUTO PROGRAM function to set up the TV for the broadcast or cable channels available in your area. If you do not run the auto program function to set up the channels, your television may not operate properly. MAIN CONTROLS PICTURE AUDIO FEATURES INSTALL LANGUAGE TUNER MODE AUTO PROGRAM CHANNEL EDIT MANUAL FINE TUNE FACTORY RESET INSTALL LANGUAGE TUNER MODE AUTO PROGRAM CHANNEL EDIT MANUAL FINE TUNE FACTORY RESET CABLE � � MENU OK SOURCE CC � � � PIP � AUTO PROGRAM (SETTING UP CHANNELS) Your LCD TV can automatically set itself for local area (or cable TV) channels. This makes it easy for you to select only the TV stations in your area by pressing the CH (+) or CH (-) button. 1 Press the MENU MENU button on the remote control to show the onscreen menu. 2 Press the (CH-) button to highlight the INSTALL menu. 3 Press the (VOL+) button to enter the INSTALL menu. 4 Press the (CH-) button to highlight the AUTO PROGRAM control. 5 Press the (VOL+) button to start the AUTO PROGRAM scanning of channels. 6 Press the MENU MENU button repeatedly to clear the menu from the screen, after AUTO STORE has finished. HELPFUL HINT • Immediately after unpacking and plugging in your new television, run the auto program function to set up the TV for the broadcast or cable channels available in your area. If you do not run the auto program function to set up the channels , your television may not operate properly. • After you've run Auto Program, check out the results. Press the CH+ or the CH- button and see which channels you can select. • Remember, an antenna or cable TV signal must first be connected to your LCD TV. MENU OK SOURCE PIP CC MAIN CONTROLS PICTURE AUDIO FEATURES INSTALL INSTALL LANGUAGE TUNER MODE AUTO PROGRAM CHANNEL EDIT MANUAL FINE TUNE FACTORY RESET LANGUAGE TUNER MODE AUTO PROGRAM CHANNEL EDIT MANUAL FINE TUNE FACTORY RESET cable INSTALL LANGUAGE TUNER MODE AUTO PROGRAM CHANNEL EDIT MANUAL FINE TUNE FACTORY RESET AUTO STORE PLEASE WAIT PROG.FOUND CHANNEL START? 0 3 5