Magnavox 37MF331D User Manual - Page 13
Installation, Select the menu language, Store TV channels - televisions
View all Magnavox 37MF331D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Installation Settings TV Setup Installation Exit Installation Language Autoprogram Weak channel installation Software upgrade Info Settings Installation Language Autoprogram Weak channel installation Software upgrade Autoprogram Start now Info Television Installation Installation mode Antenna Cable Please select your installation mode Previous Next Select the menu language 1 Press the MENU button on the remote control. 2 Use the cursor down to select Installation in the Settings menu. 3 Use the cursor right to enter the Installation menu. 4 Select Language and enter the list of available languages with the cursor right. 5 Select your preferred language with the cursor up/down and press the OK button to confirm you selection. 6 Proceed with the Installation menu. Store TV channels 1 Select Autoprogram in the Installation menu. 2 Use the cursor right to enter the Autoprogram menu. 3 Press the OK button. 4 Select Cable or Antenna in the Installation mode. When Antenna is selected, the TV will detect antenna signals and will search for antenna TV (NTSC and ATSC) channels available in your local area. When Cable is selected, the TV will detect cable company supplied signal sand will search for cable TV (NTSC, ATSC, QAM modulated) channels available in your area. Make sure that registration with your cable TV provider and connection of equipment are completed. 5 Press the green button "Next" on the remote control. Note: All channels must be unlocked in order to autoprogram. If requested, enter your PIN code to unlock all channels. See Menu preferences in the Settings, TV menu, p. 17. 6 Press the green button "Start" to start autoprogramming. The menu screen disappears and the progress of autoprogramming is displayed. The progress bar indicates the number of analog and digital TV channels found. When Autoprogramming is complete, a message appears confirming the completion and the TV switches to the first installed TV channel. Notes: • When you have locked TV channels before initiating Autoprogram, a message appears asking to enter your PIN code in order to complete Autoprogramming. • ATSC channel information is updated automatically when the TV is in standby after 3 minutes and every 3 hours thereafter. • When channel update is interrupted, the new updated channel information is retained along with the old un-updated channel information. • Background Autoprogramming occurs only when the TV is turned on. • Channel information about an ATSC channel is updated only for the ATSC channel currently tuned. • If an NTSC channel is tuned, then in Background Autoprogramming the TV shall scan all the possible ATSC frequencies and update information. • Weak channel installation allows you to manually tune weak ATSC channels in order to adjust the antenna and thus optimize signal quality for that channel. (See Installation menu, Weak channel installation, p. 14.) • Once you have searched for the available Antenna as well as the Cable TV channels, they are stored in the memory. • If Antenna/cable signal is interrupted more than ten minutes, TV will go into off mode. You are requested to press Power button or CH / button to turn on the TV. 13