Magnavox MC323 Owners Manual
Magnavox MC323 Manual
 |
View all Magnavox MC323 manuals
Add to My Manuals
Save this manual to your list of manuals |
Magnavox MC323 manual content summary:
- Magnavox MC323 | Owners Manual - Page 1
your TV is set to the correct mode (ANT), and has been properly set to scan for channels. Please refer to your TV's instruction manual for detailed instructions. A1.2: Please remove any obstructions between your antenna and the signal source. Please try to reposition the antenna and rescan for the
-
1
 |
 |
To TV
Screw sleeve
Hook & Loop
Tape
Plastic Stand
Antenna
Name
Specification
QTY
Image
Cable Clip
NO
.
1
2
2
1
Screw
M3x20mm
Part List
Φ
30mm
Installation
diagram
Table Stand Setup
Wall Mount
Adhesive Mount
VHF 174-230MHz
UHF 470-862MHz
15 Feet
User’s Manual
7
单页尺寸
90X120MM
Connection
2
(Sets)
SPECIFICATIONS AND ACCESSORIES ARE SUBJECT TO
CHANGE WITHOUT NOTICE
To Satellite Receiver/VCR
TV1
TV2
SAT
Φ
x
0.236" 1.10"
2
1. Apply one-side of the supplied Hook & Eye tape on the
rear of the Antenna.
2. Apply the other side to the desired location on the
wall.
3. Connect the corresponding Hook &
Eye sections as illustrated.
1. Drill two
Φ
0.236"
depth 1.10" holes on the wall.
2. Insert the supplied sleeves into the holes.
3. Secure the supplied screws (x 2) into the sleeves and leave 1/16 - 1/8 inch space.
4. Connect the Antenna as illustrated below.
Pitch:
1.22"
1/18-
1/8 inch
FAQs
Q1: Why can’t I get any channels from the antenna?
A1.1: Please check to ensure that your TV is set to the correct
mode (ANT), and has been properly set to scan for channels.
Please refer to your TV’s instruction manual for detailed
instructions.
A1.2: Please remove any obstructions between your antenna
and the signal source. Please try to reposition the antenna
and rescan for the desired channels.
Q2: Why am I experiencing poor reception?
A2.: Please remove any obstructions between your antenna
and the signal source. Please try to reposition the antenna
and rescan for the desired channels. It may help to place the
antenna in a higher position or close to a window.
Q3: Why can’t I get the channel I am looking for? I know
it is available in my area.
A3: There may be obstructions between the antenna and the
broadcast tower of your desired channel. Please try to
reposition the antenna and rescan for the desired channels.
It may help to place the antenna in a higher position or close
to a window.