Magnavox MD6924 Owners Manual - Page 11

Troubleshooting, General Specifications, Accessories

Page 11 highlights

TROUBLESHOOTING Check the following before requesting service: SYMPTOM POSSIBLE CAUSE AC Power cord had not connected No power The batteries were drained Cannot use battery power The AC Cord was inserted into the AC IN Jack Volume of the unit was set to minimum position No sound or sound weak Volume level of external Audio Player is in low level POSSIBLE SOLUTION Connect the AC Cord to the rear of unit and any wall outlet having AC 120V~; 60Hz Replace by new batteries Disconnect the AC Cord from the AC IN Jack Increase the volume level by turning the VOLUME Control Knob clockwise Rise the volume level of the connected external Audio Player Sound distortion Volume level too high Volume level of the connected external Audio Player too high Reduce the volume level by turning the VOLUME Control Knob counterclockwise Reduce the volume level of the connected external Audio Player CD not functioning Audio Connection Cable was inserted into the AUX IN Jack Disc is dirty or scratched CD disc incorrect install Disconnect the cable from AUX IN Jack Try other discs Place the CD disc on the center spindle with printed side face up GENERAL SPECIFICATIONS Power Source: Radio Frequency: Disc Compatible: Impedance of Speakers: Audio power: AC 120 V~; 60 Hz; 14 W, Or DC 9 V; 6 x "C" size batteries (Not included) AM: 535 - 1710 kHz FM: 87.5 - 108 MHz CD; CD-R; CD-RW 2 x 2 W; 4 Ω 0.8 W per Channel (Total 1.6 W, RMS) 1 x Owner's Manual 1 x AC Power Cord ACCESSORIES SPECIFICATIONS AND ACCESSORIES ARE SUBJECT TO CHANGE WITHOUT NOTICE 10

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12

10
Check the following before requesting service:
SYMPTOM
POSSIBLE CAUSE
POSSIBLE SOLUTION
No power
AC Power cord had not connected
Connect the AC Cord to the rear of
unit and any wall outlet having
AC 120V~; 60Hz
Cannot use battery power
The batteries were drained
Replace by new batteries
The AC Cord was inserted into the
AC IN Jack
Disconnect the AC Cord from the
AC IN Jack
No sound or sound weak
Volume of the unit was set to
minimum position
Increase the volume level by turning
the VOLUME Control Knob
clockwise
Volume level of external Audio
Player is in low level
Rise the volume level of the
connected external Audio Player
Sound distortion
Reduce the volume level by turning
the VOLUME Control Knob
counterclockwise
Volume level too high
Volume level of the connected
external Audio Player too high
Power Source:
AC 120 V~; 60 Hz; 14 W, Or
DC
9 V; 6
x
“C” size batteries (Not included)
Radio Frequency:
AM: 535 - 1710 kHz
FM: 87.5 - 108 MHz
Disc Compatible:
CD; CD-R; CD-RW
Impedance of Speakers:
2 x 2 W; 4 Ω
Audio power:
0.8 W per Channel (Total 1.6W, RMS)
1 x Owner’s Manual
1 x AC Power Cord
SPECIFICATIONS AND ACCESSORIES ARE SUBJECT TO CHANGE WITHOUT NOTICE
TROUBLESHOOTING
GENERAL SPECIFICATIONS
ACCESSORIES
Reduce the volume level of the
connected external Audio Player
CD not functioning
Audio Connection Cable was
inserted into the AUX IN Jack
Disconnect the cable from AUX IN
Jack
Disc is dirty or scratched
Try other discs
CD disc incorrect install
Place the CD disc on the center spindle
with printed side face up