Makita BJV180 Owners Manual - Page 7

Anti-splintering device 1. Base 2. Anti-splintering device 1. Dust nozzle 2. Hose for vacuum cleaner 1 2 007504 For splinter-free cuts, the anti-splintering device can be used. To install the anti-splintering device, move the tool base all the way forward and fit it from the back of tool base. When you use the cover plate, install the anti-splintering device onto the cover plate. CAUTION: • The anti-splintering device cannot be used when making bevel cuts. Dust extraction The dust nozzle (optional accessory) is recommended to perform clean cutting operations. 1 1. Dust nozzle 2. Base 2 1 007495 OPERATION CAUTION: • Always hold the base flush with the workpiece. Failure to do so may cause blade breakage, resulting in a serious injury. 1. Cutting line 2. Base 1 2 007487 2 001921 To attach the dust nozzle on the tool, insert the hook of dust nozzle into the hole in the base. The dust nozzle can be installed on either left or right side of the base. Turn the tool on without the blade making any contact and wait until the blade attains full speed. Then rest the base flat on the workpiece and gently move the tool forward along the previously marked cutting line. NOTE: • If the tool is operated continuously until the battery cartridge has discharged, allow the tool to rest for 15 minutes before proceeding with a fresh battery. When cutting curves, advance the tool very slowly. Bevel cutting 001922 007488 Then connect a Makita vacuum cleaner to the dust nozzle. CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before tilting the base. With the base tilted, you can make bevel cuts at any angle between 0° and 45° (left or right). 7