Makita CT322W XDT11 Instruction Manual - Page 8
Replacing carbon brushes
View all Makita CT322W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Replacing carbon brushes 1 1. Limit mark Replace when they wear down to the limit mark. Keep the carbon brushes clean and free to slip in the holders. All carbon brushes should be replaced at the same time. Use only identical carbon brushes. 1. Use a screwdriver to remove two screws then remove the rear cover. 1 1. Carbon brush cap 4. Make sure to place the lead wire in opposite side of the arm. 2 1 1 2 1. Rear cover 2. Screw 2. Raise the arm part of the spring and then place it in the recessed part of the housing with a slotted bit screwdriver of slender shaft or the like. 1 1. Lead wire 2. Carbon brush cap 5. Make sure that the carbon brush caps have fit into the holes in brush holders securely. 1 2 2 3 1. Recessed part 2. Spring 3. Arm 3. Use pliers to remove the carbon brush caps of the carbon brushes. Take out the worn carbon brushes, insert the new ones and replace the carbon brush caps in reverse. 8 ENGLISH 1. Hole 2. Carbon brush cap 6. Reinstall the rear cover and tighten two screws securely. 7. Insert the battery cartridge into the tool and break in brushes by running tool with no load for about 1 minute. 8. Check the tool while running and electric brake operation when releasing the switch trigger. If electric brake is not working well, ask Makita Authorized or Factory Service Centers for repair. To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should