Makita CT322W XFD01 Instruction Manual - Page 7
Operation
View all Makita CT322W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Hook 1 1. Groove 2. Hook 3. Screw Screwdriving operation 2 3 011368 The hook is convenient for temporarily hanging the tool. This can be installed on either side of the tool. To install the hook, insert it into a groove in the tool housing on either side and then secure it with a screw. To remove, loosen the screw and then take it out. Installing bit holder (Optional accessory) 1. Bit holder 1 2. Bit 2 011367 Fit the bit holder into the protrusion at the tool foot on either right or left side and secure it with a screw. When not using the driver bit, keep it in the bit holders. Bits 45 mm (1-3/4") long can be kept there. OPERATION CAUTION: • Always insert the battery cartridge all the way until it locks in place. If you can see the red part on the upper side of the button, it is not locked completely. Insert it fully until the red part cannot be seen. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. Hold the tool firmly with one hand on the grip and the other hand on the bottom of the battery cartridge to control the twisting action. 011369 CAUTION: • Adjust the adjusting ring to the proper torque level for your work. Place the point of the driver bit in the screw head and apply pressure to the tool. Start the tool slowly and then increase the speed gradually. Release the switch trigger as soon as the clutch cuts in. CAUTION: • Make sure that the driver bit is inserted straight in the screw head, or the screw and/or bit may be damaged. NOTE: • When driving wood screws, predrill pilot holes to make driving easier and to prevent splitting of the workpiece. See the chart. Nominal diameter of wood screw (mm) 3.1 (1/8") 3.5 (9/64") 3.8 (5/32") 4.5 (11/64") 4.8 (3/16") 5.1 (13/64") Recommended size of pilot hole (mm) 2.0 - 2.2 (5/64" - 3/32") 2.2 - 2.5 (3/32" - 3/32") 2.5 - 2.8 (3/32" - 7/64") 2.9 - 3.2 (7/64" - 1/8") 3.1 - 3.4 (1/8" - 9/64") 3.3 - 3.6 (1/8" - 9/64") 001904 5.5 (7/32") 5.8 (7/32") 6.1 (15/64") 3.7 - 3.9 (9/64" - 5/32") 4.0 - 4.2 (5/32" - 11/64") 4.2 - 4.4 (11/64" - 11/64") Drilling operation First, turn the adjusting ring so that the pointer points to the marking. Then proceed as follows. Drilling in wood When drilling in wood, the best results are obtained with wood drills equipped with a guide screw. The guide screw makes drilling easier by pulling the bit into the workpiece. Drilling in metal To prevent the bit from slipping when starting a hole, make an indentation with a center-punch and hammer at the point to be drilled. Place the point of the bit in the indentation and start drilling. Use a cutting lubricant when drilling metals. The exceptions are iron and brass which should be drilled dry. 7