Makita HR2475 Owners Manual - Page 6
Bit grease, Installing or removing the bit, Bit angle when chipping, scaling or, demolishing, Depth - drill
View all Makita HR2475 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Bit grease Coat the bit shank head beforehand with a small amount of bit grease (about 0.5 -1 g; 0.02 - 0.04 oz.). This chuck lubrication assures smooth action and longer service life. Installing or removing the bit 1. Bit shank 2. Bit grease 1 2 009664 Clean the bit shank and apply bit grease before installing the bit. Insert the bit into the tool. Turn the bit and push it in until it engages. After installing, always make sure that the bit is securely held in place by trying to pull it out. 1. Bit 2. Chuck cover 1 2 Bit angle (when chipping, scaling or demolishing) 1. Action mode changing knob 2. Lock button 1 2 010164 The bit can be secured at the desired angle. To change the bit angle, depress the lock button and rotate the action mode changing knob to the O symbol. Turn the bit to the desired angle. Depress the lock button and rotate the action mode changing knob to the symbol. Then make sure that the bit is securely held in place by turning it slightly. 010165 010162 Depth gauge To remove the bit, pull the chuck cover down all the way and pull the bit out. 1. Bit 1 2. Chuck cover 2 1 010166 1. Depth gauge 010163 The depth gauge is convenient for drilling holes of uniform depth. Loosen the side grip and insert the depth gauge into the hole in the side grip. Adjust the depth gauge to the desired depth and tighten the side grip. NOTE: • The depth gauge cannot be used at the position where the depth gauge strikes against the gear housing. 6