Makita XAG26Z XAG26 Instruction Manual - Page 8

Indicating the remaining battery capacity Only for battery cartridges with the indicator 1 Indicating the remaining battery capacity When you turn the tool on, the battery indicator shows the remaining battery capacity. 1 2 ► 1 . Indicator lamps 2. Check button Press the check button on the battery cartridge to indicate the remaining battery capacity. The indicator lamps light up for a few seconds. Indicator lamps Remaining capacity Lighted Off Blinking 75% to 100% ► 1 . Battery indicator The remaining battery capacity is shown as the following table. Battery indicator status On Off Blinking Remaining battery capacity 50% to 100% 50% to 75% 25% to 50% 20% to 50% 0% to 25% 0% to 20% Charge the battery. The battery may have malfunctioned. Charge the battery Tool / battery protection system NOTE: Depending on the conditions of use and the ambient temperature, the indication may differ slightly from the actual capacity. NOTE: The first (far left) indicator lamp will blink when the battery protection system works. The tool is equipped with a tool/battery protection system. This system automatically cuts off power to the motor to extend tool and battery life. The tool will automatically stop during operation if the tool or battery is placed under one of the following conditions: Overload protection When the tool/battery is operated in a manner that causes it to draw an abnormally high current, the tool automatically stops without any indication. In this situation, turn the tool off and stop the application that caused the tool to become overloaded. Then turn the tool on to restart. Overheat protection When the tool is overheated, the tool stops automatically and the battery indicator shows following state. In this situation, let the tool cool before turning the tool on again. 8 ENGLISH