Makita XBU02Z XBU02 Instruction Manual - Page 5
Tool / battery protection system, Remaining battery capacity, indication, Switch action
View all Makita XBU02Z manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
NOTE: • The tool does not work with only one battery cartridge. Tool / battery protection system The tool is equipped with a tool/battery protection system. This system automatically cuts off power to the motor to extend tool and battery life. The tool will automatically stop during operation if the tool or battery is placed under one of the following conditions. In some conditions, the indicators light up. Overload protection When the tool is operated in a manner that causes it to draw an abnormally high current, the tool automatically stops without any indication. In this situation, turn the tool off and stop the application that caused the tool to become overloaded. Then turn the tool on to restart. Overheat protection for tool On Blinking 015485 When the tool is overheated, the tool stops automatically, the battery indicator blink about 60 seconds. In this situation, let the tool cool down before turning the tool on again. Overdischarge protection When the battery capacity becomes low, the tool stops automatically. If the product does not operate even when the switches are operated, remove the batteries from the tool and charge the batteries. Remaining battery capacity indication 1. Battery indicator 2. Check button Press the check button to make the battery indicators show the remaining battery capacities. The battery indicators correspond to each battery. Remaining battery capacity indication Battery indicator status Remaining battery capacity On Off Blinking 50% - 100% 20% - 50% 0% - 20% Charge the battery 015527 Switch action CAUTION: • Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. 1. Switch trigger 1 015478 To start the tool, simply pull the switch trigger. Tool speed is increased by increasing pressure on the switch trigger. Release the switch trigger to stop. 1 1. Lock button 1 1 21 015476 015479 5