Makita XDT16T XDT16 Instruction Manual - Page 12

To install the driver bit, insert it into the sleeve as far as it will go. OPERATION 1 2 ► 1 . Driver bit 2. Sleeve To remove the driver bit, pull the sleeve in the direction of the arrow and pull the driver bit out. NOTE: If the driver bit is not inserted deep enough into the sleeve, the sleeve will not return to its original position and the driver bit will not be secured. In this case, try re-inserting the bit according to the instructions above. NOTE: When it is difficult to insert the driver bit, pull the sleeve and insert it into the sleeve as far as it will go. NOTE: After inserting the driver bit, make sure that it is firmly secured. If it comes out, do not use it. Installing hook CAUTION: When installing the hook, always secure it with the screw firmly. If not, the hook may come off from the tool and result in the personal injury. The proper fastening torque may differ depending upon the kind or size of the screw/bolt, the material of the workpiece to be fastened, etc. The relation between fastening torque and fastening time is shown in the figures. Proper fastening torque for standard bolt N•m (ft•lbs) 140 (101) 120 (87) 100 (72) 2 80 (58) 60 (43) 40 (29) 20 (14) M16(5/8") M14(9/16") M16(5/8") M12(1/2") M10(3/8") M8(5/16") M14(9/16") M12(1/2") M10(3/8") M8(5/16") 0 1 2 1 1. Fastening time (second) 2. Fastening torque 1 2 3 ► 1 . Groove 2. Hook 3. Screw The hook is convenient for temporarily hanging the tool. This can be installed on either side of the tool. To install the hook, insert it into a groove in the tool housing on either side and then secure it with a screw. To remove, loosen the screw and then take it out. 12 ENGLISH