Makita XRH04 Makita XRH04 Instruction Manual - Page 7
Installing or removing the bit, Bit angle, when chipping, scaling or demolishing, Depth gauge, Dust
View all Makita XRH04 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Installing or removing the bit Clean the bit shank and apply bit grease before installing the bit. 1. Bit shank 1 2. Bit grease The bit can be secured at the desired angle. To change the bit angle, depress the lock button and rotate the action mode changing knob to the O symbol. Turn the bit to the desired angle. Depress the lock button and rotate the action mode changing knob to the symbol. Then make sure that the bit is securely held in place by turning it slightly. 2 001296 Insert the bit into the tool. Turn the bit and push it in until it engages. 1. Bit 2. Chuck cover 1 2 009129 Depth gauge 1 1. Depth gauge 009126 If the bit cannot be pushed in, remove the bit. Pull the chuck cover down a couple of times. Then insert the bit again. Turn the bit and push it in until it engages. After installing, always make sure that the bit is securely held in place by trying to pull it out. To remove the bit, pull the chuck cover down all the way and pull the bit out. 1. Bit 2. Chuck cover 1 2 009127 Bit angle (when chipping, scaling or demolishing) 1. O symbol 2. Action mode changing knob 1 2 009128 009130 The depth gauge is convenient for drilling holes of uniform depth. Loosen the side grip and insert the depth gauge into the hole in the side grip. Adjust the depth gauge to the desired depth and tighten the side grip. NOTE: • The depth gauge cannot be used at the position where the depth gauge strikes against the gear housing. Dust cup 1. Dust cup 1 001300 Use the dust cup to prevent dust from falling over the tool and on yourself when performing overhead drilling operations. Attach the dust cup to the bit as shown in the figure. The size of bits which the dust cup can be attached to is as follows. 7