Makita XSS03Z XSS03Z Instruction Manual - Page 11

1 007981 1. Adjusting screw for 90 ﾟ To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts. OPTIONAL ACCESSORIES CAUTION: • These accessories or attachments are recommended for use with your Makita tool 1. Triangular rule 1 specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. • Carbide-tipped saw blades 007982 Replacing carbon brushes 1. Limit mark 1 001145 Remove and check the carbon brushes regularly. Replace when they wear down to the limit mark. Keep the carbon brushes clean and free to slip in the holders. Both carbon brushes should be replaced at the same time. Use only identical carbon brushes. Use a screwdriver to remove the brush holder caps. Take out the worn carbon brushes, insert the new ones and secure the brush holder caps. 1. Brush holder 1 cap 2 2. Screwdriver Combination General purpose blade for fast and smooth rip, crosscuts and miters. 006540 • Rip fence (Guide rule) • Hex wrench 5 • Dust nozzle • Makita genuine battery and charger NOTE: • Some items in the list may be included in the tool package as standard accessories. They may differ from country to country. 007983 After replacing brushes, insert the battery cartridge into the tool and break in brushes by running tool with no load for about 1 minute. Then check the tool while running and electric brake operation when releasing the switch trigger. If electric brake is not working well, ask your local Makita service center for repair. 11