Marantz AV7703 Owner s Manual In English - Page 259

Contents Connections Playback 1 Press and hold down the input source select button that you want to register the preset code to and SET until "PRSET" indicator on the remote control display is flashing, then release. 2 Enter the preset number (4 digits) listed for the device in the Preset Code Table using the number buttons (0 - 9) on the remote control. 0 Some manufacturers use more than one type of remote control code. Preset codes to change the number and verify correct operation. 0 If the device does not operate even when the preset code is registered, use the learning function. Remote codes for different devices can be remembered for use by the Marantz remote control included with this device. (v p. 265) NOTE 0 Depending on the model and year of manufacture of your device, some buttons may not operate. Settings Tips Appendix o Experimenting with preset codes one by one for registration 1 Switch the power on of the device for which you want to set the preset code. 2 Press and hold down the input source select button that you want to register the preset code to and SET until "PRSET" indicator on the remote control display is flashing, then release. 3 Aim the remote control at the appliance and slowly alternate between pressing CH/PAGE d and DEVICE X for the appliance. The preset code is shown in the remote control display. 4 Stop when the appliance turns off. 5 Press ENTER once to lock in the code. Front panel Display Rear panel 259 Remote Index