Maytag CWE4800ACB Installation Instructions

Maytag CWE4800ACB - 24 Inch Single Electric Wall Oven Manual

Maytag CWE4800ACB manual content summary:

  • Maytag CWE4800ACB | Installation Instructions - Page 1
    INSTALLATION INSTRUCTIONS 24" (61.0 CM) ELECTRIC SINGLE AND DOUBLE BUILT-IN OVEN Table of Contents BUILT-IN OVEN SAFETY 1 INSTALLATION REQUIREMENTS 2 Tools and Parts 2 Location Requirements 2 Electrical Requirements 3 INSTALLATION INSTRUCTIONS 4 Prepare Built-In Oven 4 Oven Door 4 Make
  • Maytag CWE4800ACB | Installation Instructions - Page 2
    drill (for wall cabinet installations) ■ 1" (25 mm) drill bit (for wall cabinet installations) ■ Level Parts needed ■ UL listed or CSA approved conduit connector ■ UL listed wire connectors Parts supplied ■ 0.188 x 2.1" screws - single oven (4), double oven (6) Check local codes. Check existing
  • Maytag CWE4800ACB | Installation Instructions - Page 3
    113.4 cm) recessed height Cabinet Dimensions - Double Oven Double Oven Installed in Cabinet A B F D E C A. 24" (61 cm) min. instructions provided for it here. ■ Oven must be connected to the proper electrical voltage and frequency as specified on the model/serial number rating plate. The model
  • Maytag CWE4800ACB | Installation Instructions - Page 4
    manufacturer's recommended procedure. Aluminum/copper connection must conform with local codes and industry accepted wiring practices. INSTALLATION INSTRUCTIONS Prepare Built-In Oven 1. Decide on the final location for the oven. Locate existing wiring to avoid drilling into or severing wiring
  • Maytag CWE4800ACB | Installation Instructions - Page 5
    For Double Ovens Make Electrical Connection For Single Ovens WARNING WARNING Electrical Shock Hazard Disconnect power before servicing. Use 8 gauge solid copper wire. Electrically ground oven. Failure to follow these instructions can result in death, fire, or electrical shock. Electrical Shock
  • Maytag CWE4800ACB | Installation Instructions - Page 6
    power supply in the U.S. where local codes do not allow grounding through neutral, New Branch circuit installations (1996 NEC), mobile homes and (H) from the oven cable to the green (or bare) ground wire (in the junction box) using a UL listed wire connector. 6. Install junction box cover
  • Maytag CWE4800ACB | Installation Instructions - Page 7
    hinges. 8. Close door. 9. Repeat for lower oven door. 10. Reconnect power. 11. Display panel will light briefly, and "PF" should appear in the display. 12. If display panel does not light, please reference the "Assistance or Service" section of the Use and Care Guide or contact the dealer from whom
  • Maytag CWE4800ACB | Installation Instructions - Page 8
    See the User Instructions for more information. If oven(s) does not operate, check the following: If you need Assistance or Service: Please reference the "Assistance or Service" section of the Use and Care Guide or contact the dealer from whom you purchased your built-in oven. ■ Household fuse is
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8

INSTALLATION INSTRUCTIONS
24" (61.0 CM) ELECTRIC SINGLE AND DOUBLE
BUILT-IN OVEN
BUILT-IN OVEN SAFETY
IMPORTANT:
Save for local electrical inspector's use.
W10203506A
Table of Contents
BUILT-IN OVEN SAFETY
...............................................................
1
INSTALLATION REQUIREMENTS
................................................
2
Tools and Parts
............................................................................
2
Location Requirements
...............................................................
2
Electrical Requirements
...............................................................
3
INSTALLATION INSTRUCTIONS
..................................................
4
Prepare Built-In Oven
..................................................................
4
Oven Door
....................................................................................
4
Make Electrical Connection
.........................................................
5
Install Oven
..................................................................................
7
Complete Installation
...................................................................
8
You can be killed or seriously injured if you don't immediately
You
can be killed or seriously injured if you don't follow
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.”
These words mean:
follow instructions.
instructions.
DANGER
WARNING