Maytag MAL2000AXW Instruction Sheet
Maytag MAL2000AXW - Neptune Washer/Dryer Platform Manual
 |
View all Maytag MAL2000AXW manuals
Add to My Manuals
Save this manual to your list of manuals |
Maytag MAL2000AXW manual content summary:
- Maytag MAL2000AXW | Instruction Sheet - Page 1
- 1102 ACCESSORY MODEL NO. : MAL2000AXW, MAL2000AXQ, DESCRIPTION : Maytag Neptune Riser This riser is approved for use with only the Maytag Neptune washer and dryer pair. Weight = 70 lb/26 kg. IMPORTANT TO INSTALLER PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY BEFORE STARTING TO UNINSTALL - Maytag MAL2000AXW | Instruction Sheet - Page 2
instructions floor prior to pedestal installation. 5. riser a minimum of 5 inches from the wall. This will allow sufficient room for dryer venting, inlet hoses and drain hose attachments. This will enable access to the exhaust system for maintenance as recommended in the Dryer care & use manual - Maytag MAL2000AXW | Instruction Sheet - Page 3
Single person lift could cause injury. Use assistance when moving or lifting. * Note the squares on the top surface. Figure 1 WALL 5 Inches Minimum RISER Figure 3 Figure 2 6. Tilt each laundry product forward and measure how far down the rear legs are from the bottom of the unit. (Approximately - Maytag MAL2000AXW | Instruction Sheet - Page 4
6 & 7 2. Make sure the front legs are positioned into the square rings on the front of the riser. Figure 8 Figure 7 3. Follow the Installation Instructions that came with your dryer to finish installing the unit. (i.e. electrical hookup, vents and etc.) Note: For gas dryers the installation
-
1 -
2 -
3 -
4
 |
 |
Instruction
Sheet
6
2727950 - 1102
This instruction sheet is to be used with :
ACCESSORY MODEL NO. :
MAL2000AXW, MAL2000AXQ,
DESCRIPTION :
Maytag Neptune
Riser
1
Kit Contains:
Qnty
.
Description
1
Neptune
Riser
4
Leveling Legs
4
Locking Nuts
1
Instruction Sheet
TOOLS REQUIRED:
•
Teflon Tape or Pipe Joint Compound
(gas only)
•
Cutting Knife
•
Pipe Wrench
•
Nut Drivers
•
Level
•
Duct Tape
•
Crescent Wrench
•
Bucket or pail w/towels
This riser is approved for use with only the
Maytag Neptune
washer and dryer pair.
Deinstallation and Reinstallation of the Maytag Neptune
Washer and
Dryer must conform with local codes.
IMPORTANT TO INSTALLER
PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY BEFORE STARTING TO
UNINSTALL AND REINSTALL YOUR APPLIANCES. THESE INSTRUCTIONS SHOULD BE
RETAINED FOR FUTURE REFERENCE.
Weight = 70 lb/26 kg.