Maytag MDB7749SAW Use & Care Guide - Page 6
Controls And Cycle Status, Control, Purpose, Comments, Option Selections, Options, Dish Load Types,
View all Maytag MDB7749SAW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
OPTION SELECTIONS OPTIONS dish load types DESCRIPTIONS USE WITH: ADDED TIME TO CYCLE Tough food soils All loads Loads requiring extra drying To sanitize your dishes and glassware All loads Increases the target water temperature during the wash portions of the cycle. Adds heat, time, and water. Jet Clean Plus Steam, Normal, and Auto Clean Use for best drying results in combination with rinse aid. Turn off when loads contain plastic dinnerware that may be sensitive to higher temperatures. Use for best drying results in combination with rinse aid. Turn off when loads contain plastic dinnerware that may be sensitive to higher temperatures. Raises the water temperature in the final rinse to approximately 154°F (68°C). This high temperature rinse sanitizes your dishes and glassware in accordance with NSF/ANSI Standard 184 for Residential Dishwashers. Certified residential dishwashers are not intended for licensed food establishments.The Sanitize option adds heat and time to the cycle. Delays the start of a cycle up to 8 hours. Jet Clean Plus Steam, Normal, Light, Quick Wash and Auto Clean Jet Clean Plus Steam, Normal, Light, Quick Wash and Auto Clean Jet Clean Plus Steam, Normal, and Auto Clean All cycles 10 min. 45 min. 90 min. 30 min. 2, 4, 8 hours All loads When Control Lock is lit, all buttons are disabled. If you press any pad while your dishwasher is locked, the light flashes. The door can be opened while the controls are locked. All cycles CONTROLS AND CYCLE STATUS CONTROL PURPOSE To start or resume a wash cycle To reset any cycle or options during selection. To cancel a wash cycle after it's started. To turn the audible tones on or off. COMMENTS If the door is opened during a cycle or the power is interrupted, the START/RESUME indicator flashes. The cycle will not resume until the door is closed and START/RESUME is pressed. NOTE: If the START/RESUME button is located on top of door, push door firmly closed within 3 seconds of pressing START/RESUME. If the door is not closed within 3 seconds, the start button LED will flash, an audible tone will be heard, and the cycle will not start. Press CANCEL/DRAIN to reset any control selections made. See "Canceling A Cycle" and "Changing a Cycle After Dishwasher Is Started" sections. Press and hold the Hi Temp Wash button for 3 seconds to turn the audible tones on or off. Only audible tones for confirming button presses can be turned on/off. Important audible tones, such as indicating a cycle has been interrupted, cannot be deactivated. 6