Maytag MGD6000XR Installation Instructions - Page 13
Turn on cold water faucet
View all Maytag MGD6000XR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
3. Tighten couplings 5. Attach long hose to dryer fill valve and tighten coupling A Using pliers, tighten the couplings with additional two-thirds turn. NOTE: Do not overtighten. Damage to the coupling can result. 4. A ttach long hose to "Y" connector and tighten couplings Remove protective cap from water inlet valve. Attach other end of long hose to fill valve at bottom of dryer back panel. Screw on coupling by hand until it is seated on fill valve connector. Using pliers, tighten the couplings an additional two-thirds turn. NOTE: Do not overtighten. Damage to the coupling can result. 6. Turn on cold water faucet One end of the long hose has a wire mesh strainer inside the coupling. Attach this end to the "Y" connector. Attach washer cold inlet hose to other side of "Y" connector. Screw on coupling by hand until it is seated on connector. Using pliers, tighten the couplings an additional two-thirds turn. NOTE: Do not overtighten. Damage to the coupling can result. Check that the water faucets are turned on. 7. Check for leaks Check for leaks around "Y" connector, faucet, and hoses. 13