Maytag MGD8100DW Installation Guide - Page 4
Installation Requirements
View all Maytag MGD8100DW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
INSTALLATION REQUIREMENTS TOOLS AND PARTS Gather the required tools and parts before starting installation. Tools needed for all installations: Parts supplied (all models): Flat-blade screwdriver #2 Phillips screwdriver Leveling legs (4) Parts supplied (steam models): 1/4" and 5/16" nut driver (recommended) Level "Y" connector 2' (0.6 m) inlet hose Tape measure Utility knife Pliers Rubber washer Tin snips (new vent installations) Parts package is located in dryer drum. Check that all parts are included. NOTE: Do not use leveling legs supplied with dryer if installing with a pedestal or a stack kit. Parts needed: (Not supplied with dryer) ■■Vent clamps ■■Vent elbows and vent work Parts needed (steam models): Caulking gun and compound Adjustable wrench that opens to (new vent installations) 1" (25 mm) or hex-head socket wrench Tools needed for gas installations: 5' (1.52 m) inlet hose 8" or 10" pipe wrench 8" or 10" adjustable wrench (for gas connections) Additional parts may be required, depending in your installation. Check local codes. Check existing electrical supply and venting. Read "Electrical Requirements" and "Venting Requirements" before purchasing parts. Optional Equipment: (Not supplied with dryer) Refer to your Use and Care Guide for information about accessories available for your dryer. Pipe-joint compound resistant to LP gas 4