Maytag MGDB200VQ Installation Instructions - Page 15
Reverse Door Swing
UPC - 883049140568
View all Maytag MGDB200VQ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
REVERSE DOOR SWING You can change your door swing from a right-side opening to a left-side opening, if desired. 1. Place a towel or soft cloth on top of dryer or work space to avoid damaging the surface. Remove the door assembly 1. Open the dryer door. 2. Remove the bottom screw (B) from each of the two hinges that attach dryer door to front panel of dryer. 3. Loosen the top screw (A) from each of the two hinges in Step 2. Reverse the strike 1. Remove the door strike (A) from the dryer door opening. 2. Remove the cosmetic screw (B) opposite the door strike (A). A B A B A B 4. Remove the dryer door and the hinges by lifting upward on the door. Lay the door on a flat, covered surface, with the inside of the door facing up. Remove remaining two loose screws from dryer front panel. 5. Remove the 4 plastic plugs (A) located outside the dryer door opening. A A A. Door strike B. Cosmetic screw 3. R einstall the door strike and cosmetic screw on the opposite side of dryer door opening from where they were removed. NOTE: Door strike and plugs must be on the same side of the dryer door opening. Reinstall the door 1. Remove the 4 screws and two hinges from the dryer door. 2. Replace the 4 screws in the same holes 3. Remove the 4 screws from the opposite side of the door. A A 6. Install 4 plastic plugs (A) into screw holes in the dryer left where the hinges were removed in Step 4. 15