Maytag MHW5630HW Owners Manual - Page 21

TROUBLESHOOTING First try the solutions suggested here or visit our website at www.maytag.com/product_help - In Canada www.maytag.ca for assistance and to possibly avoid a service call. If you experience Possible Causes Solution Error Code Appears in Display (for 2- and 3-digit displays) (cont.) "rL" (remove load) appears in display Load detected in drum during Clean Remove items from washer drum and restart Clean Washer Washer with affresh® cycle. with affresh® cycle. Loc Control is locked. This is not an error code but just an indication that the control is locked. Press and hold the control lock key for three seconds to unlock. F# E# or F## E## code other than as described above appears in display System error code. Washer making error beeps Door has not been opened and closed for at least 3 cycles. Washer beeps when START is touched Door not closed. CL appears on display, or The washer has run 30 wash cycles Clean Washer LED flashing and is indicating a reminder to run at end of wash cycle (on the Clean Washer with affresh® cycle. some models) Washer won't start Control lock could be enabled. "PF" F0 E5 or "ob" "dr" or F5 E4 Appears upon recovery from power loss, if power was lost while running a cycle. Off balance load detected. This means that your washer detected an off balance load and that caused the cycle to take longer than usual or the clothes to be more wet than usual. Door not opened between cycles. Touch POWER once to clear the code. Then touch POWER again and restart the washer. If code appears again, call for service. Unplug washer for 30 seconds, then plug back in. This code may occur when the washer is first turned on. Open and close the door to clear the display. Close the door completely. Run the Clean Washer with affresh® cycle. If the Clean Washer with affresh® cycle is not turned on, the LED will stop flashing at the end of a wash cycle after running 3 more regular wash cycles. After 30 more wash cycles are completed, the Clean Washer with affresh® LED will again flash at the end of a wash cycle as a reminder. To check whether the unit is in control lock, try powering On the unit. On doing that if you see the code 'Loc' displayed in the seven segment display, then you know that control is locked. To unlock controls press and hold the 'control lock' key for three seconds. Be sure the door is closed. Make sure you press and hold the start button for 1 full second. Make sure the door has been opened and closed since the last cycle was run. Touch POWER once to clear the code. Then touch POWER again and restart the washer. Touch POWER once to clear the code. Then touch POWER again and restart the washer. Open and close the door. Touch POWER once to clear the code. Then touch POWER again and restart the washer. 21