Maytag MHW5630MBK Owners Manual - Page 5

Locate the Load & Go™ bulk dispenser. Gently pull up on the tab located on the bulk dispenser lid to lift the fill door. Fill to the "MAX" line (see illustrations at right) with HE liquid detergent or liquid fabric softener (1-liter dispenser only). Close fill door. It will click into place. Make sure the concentration setting is correct (see the online "Cycle Guide"). It is recommended that you rinse out the Load & Go™ containers when refilling, when changing detergent types or concentrations, or when the washer will not be used for an extended period. For instructions on cleaning the dispenser cartridge, see "Washer Care" in the "Washer Maintenance and Care" section of your Owner's Manual. Adding HE detergent to single-load dispenser: Pour a measured amount of HE detergent into detergent compartment. For powdered detergent, lift the selector to the high position. For liquid detergent, push down the selector to the low position. Do not overfill; adding too much detergent may cause detergent to be dispensed into the washer too early. IMPORTANT: � Disable the Load & Go™ option before starting a single load (on some models). The Optimal Dispense Drawer cannot be disabled. � Do not add single-dose laundry packet to dispenser drawer. Powdered detergent: Liquid detergent: Lift the selector to the high position. Add directly to the compartment. Push down the selector to the low position. Add directly to the compartment. NOTE: Unless the Optimal Dispense Drawer is empty, it is not recommended to use powdered detergent. WASHER MAINTENANCE AND CARE Cleaning the Washer Location Keep washer area clear and free from items that would block airflow. This includes clearing piles of laundry in front of the washer. Water Inlet Hoses Replace inlet hoses after 5 years of use to reduce the risk of hose failure. Periodically inspect and replace inlet hoses if bulges, kinks, cuts, wear, or leaks are found. When replacing your inlet hoses: � Mark the date of replacement on the label with a permanent marker. � Check that the old washers are not stuck on the washer inlet valves. � Use new washers in the new inlet hoses to ensure a proper seal. Washer Care Recommendations to Help Keep Your Washer Clean and Performing at Its Best 1. Always use High Efficiency (HE) detergents and follow the HE detergent manufacturer's instructions regarding the amount of HE detergent to use. Never use more than the recommended amount because that may increase the rate at which detergent and soil residue accumulate inside your washer, which, in turn, may result in undesirable odor. 2. Use warm or hot water washes sometimes (not exclusively cold water washes), because they do a better job of controlling the rate at which soils and detergent accumulate. 3. Always leave the washer lid open between uses to help dry out the washer and prevent the buildup of odor-causing residue. 4. Periodically clean residue from all interior surfaces of the window. For better care, wipe the entire inside of the door with a damp cloth. Cleaning Your Front-Loading Washer Read these instructions completely before beginning the routine cleaning processes recommended below. This Washer Maintenance Procedure should be performed, at a minimum, once per month or every 30 wash cycles, whichever occurs sooner, to control the rate at which soils and detergent may otherwise accumulate in your washer. Cleaning the Door Seal 1. Open the washer door and remove any clothing or items from the washer. 2. Inspect the gray-colored seal between the door opening and the drum for stained areas, soil buildup, or lint. Pull back the seal to inspect all areas under the seal and to check for foreign objects or lint. 5