Maytag MHW6000XG Use & Care Guide - Page 11

8. Select CYCLE heavy duty normal wrinkle control whites bedding allergen small load rinse/drain & spin soak Steam model shown clean washer with delicate Turn cycle knob to select your wash cycle. See "Cycle Guide" for details on cycle features. Not all options and settings are available on all cycles. 9. Adjust settings, if desired + - temp level soil level spin speed Steam model shown extra rinse oxi boost max extract cycle signal control lock press and hold for 3 seconds The display will show the default settings for the selected cycle. If desired, press the button beneath each setting to adjust the Temp Level, Soil Level, and Spin Speed. Adjusting the Soil Level will change the Estimated Time Remaining. Overloading, unbalanced loads, or excessive suds may also cause the washer to increase the cycle time. NOTE: Not all settings are available on all cycles. See "Cycle Guide" for available settings. 10. Select any additional options fresh hold steam for stains press & hold for drum light Steam model shown extra rinse oxi boost max extract cycle signal control lock press and hold for 3 seconds To add additional options to the cycle, such as Extra Rinse, Fresh Hold, Stain Clean/Steam for Stains (on some models), or Max Extract (on some models), press the button for the desired options to add them to the selected cycle. NOTE: Not all options are available with all cycles. See "Cycle Guide" for available options. 11. Setting a delayed start + - temp level soil level If you do not want to begin a cycle immediately, you may choose the DELAY START option. This will delay the start of the wash cycle by up to 10 hours on models with Steam, and 8 hours on non-Steam models. To set a delayed Start: 1. Press DELAY START s and t buttons to set the desired delay time. 2. Press START/PAUSE to set the delay. The delay countdown has started when the START/PAUSE light stops blinking. 12. Press and hold START/PAUSE to begin wash cycle start pause press and hold to start Press and hold the START/PAUSE button to start the wash cycle. To pause a cycle in progress, press the START/PAUSE button once, then press and hold again to continue the cycle. To cancel a cycle, press the POWER/CANCEL button. Once you press and hold START/PAUSE, you will hear the door lock, unlock, and lock again. The washer door will remain locked during the wash cycle. Unlocking the door to add garments: If you need to open the door to add 1 or 2 missed garments, you may do so while the "Add a Garment" light is lit. Press START/PAUSE once; the door will unlock once the washer movement has stopped. start This may take several minutes. Then close door and press START/PAUSE again to restart the cycle. pause press and hold to start 11