Maytag MSD2656KGB Use and Care Manual - Page 28
Replacing Light Bulbs
View all Maytag MSD2656KGB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Care and Cleaning Replacing Light Bulbs WARNING To avoid electrical shock which can cause severe personal injury or death, disconnect power to refrigerator before replacing light bulb. After replacing light bulb, reconnect power. CAUTION To avoid personal injury or property damage, observe the following: • Allow light bulb to cool. • Wear gloves when replacing light bulb. Upper Fresh Food Section The upper fresh food light bulbs are located behind the front panel. Reach behind the panel to remove the bulbs. Lower Fresh Food Section 1. Push up on bottom tabs on light cover. Rotate cover up and release tabs. 2. Remove light bulb. 3. Replace bulb with appliance bulb no greater than 40 watts. 4. Insert top tabs of light cover into liner slots and snap bottom tabs into liner slots. Upper Freezer Section 1. Remove ice bin by lifting front of bin and pulling out. 2. Remove light shield by pressing the upper right side of the shield and rotating downward. 3. Remove light bulb. Replace with appliance bulb no greater than 40 watts. 4. Rotate the shield upward, press in slightly and snap into place. 5. Replace ice bin by sliding in until bin locks into place. Lower Freezer Section 1. Pinch both sides of light cover to remove. 2. Remove light bulb. Replace with appliance bulb no greater than 40 watts. 3. Pinch both sides of the light cover to snap into place. Ice and Water Dispenser 1. Locate light bulb inside top edge of dispenser frame. Unscrew to remove. 2. Replace light bulb with a 7-watt, 120 volt bulb. Light Bulb Location 27