Maytag MVWB800VU Use and Care Manual - Page 7

Installation Instructions

Get Maytag MVWB800VU - 28inch Washer With SuperSize Capacity Plus PDF manuals and user guides
UPC - 883049140421
View all Maytag MVWB800VU manuals
Add to My Manuals
Save this manual to your list of manuals

Page 7 highlights

■■ Check with a qualified electrician if you are not sure the washer is properly grounded. ■■ Do not have a fuse in the neutral or ground circuit. IMPORTANT: ■■ Be sure the foam shipping base has been removed from the bottom of the washer as directed in the Unpacking Instructions. ■■ If foam shipping base has not been removed, be sure lid is secured with tape before laying washer on its back. ■■ Removing the foam shipping base is necessary for proper operation. Remove Shipping Base and Packing Ring 1. Place cardboard supports from shipping carton on floor behind washer for support. 2. Secure the lid with tape. 3. Using 2 or more people, tip the washer onto its back and place on cardboard supports. 4. Remove foam shipping base. INSTALLATION INSTRUCTIONS Before You Start 5. Set washer upright. 6. Remove tape from lid. Open lid and remove foam packing ring from washer tub. Keep foam packing ring in case you need to move the washer in the future. NOTE: To avoid floor damage during installation, set the washer onto cardboard before moving across floor. 7

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
7
Check with a qualified electrician if you are not sure the washer is properly grounded.
±
■
Do not have a fuse in the neutral or ground circuit.
±
■
INSTALLATION INSTRUCTIONS
Before You Start
NOTE:
To avoid floor damage during installation, set the washer onto cardboard before
moving across floor.
IMPORTANT:
Be sure the foam shipping base has been removed from the bottom of the washer as
±
■
directed in the Unpacking Instructions.
If foam shipping base has not been removed, be sure lid is secured with tape before laying
±
■
washer on its back.
Removing the foam shipping base is necessary for proper operation.
±
■
Remove Shipping Base and Packing Ring
1.
Place cardboard supports from shipping carton on floor behind washer for support.
2.
Secure the lid with tape.
3.
Using 2 or more people, tip the washer onto its back and place on cardboard supports.
4.
Remove foam shipping base.
5.
Set washer upright.
6.
Remove tape from lid. Open lid and remove foam packing ring from washer tub.
Keep foam packing ring in case you need to move the washer in the future.