Maytag MVWB835DC Use & Care Guide - Page 6

6 OPTIONS Use to select available options for your dryer. Not all cycles and options are available on all models. Energy Saver Activate the ENERGY SAVER setting to increase your energy savings. This setting uses a lower heat level and extends cycle time. Turn on for optimal energy savings. Turn off for optimal cycle times. ENERGY SAVER will default on for Normal. NOTE: Energy savings is not available on all cycles and may vary across loads and cycles. Static Reduce (on some models) Touch to add the Static Reduce option to selected Sensor cycles (see "Cycle Guide"). The dryer will automatically tumble, pause, and introduce a small amount of moisture into the load to help reduce static. This option adds approximately 8 minutes to the total cycle time. Damp Dry Signal Touch to select the Damp Dry Signal to Low, High, or Off. When selected, a series of beeps will sound when the load is damp, but not completely dry. This will allow you to take clothes out of the load that do not need to dry completely. This option is not available on Sanitize, Steam Refresh, and the Timed Dry cycles. Audio Level Touch AUDIO LEVEL to change end beep and button sounds simultaneously to Low, High, or Off. 7 CYCLE STATUS LIGHTS The indicator bar on the right side of the control will let you know what stage of the drying cycle is in process. For more information on each stage, see "Cycle Status Indicators." Sensing The Sensing indicator will light during Sensor Cycles to indicate that the moisture sensor on the dryer is operating. This indicator will not light during Timed Cycles or options such as Wrinkle Prevent. Check Vent The Check Vent indicator will light if there is a blocked vent or low airflow. Good Airflow This indicator will light if there is no major vent blockage. Steam This indicator will light when a steam function is active. NOTE: Steam is not available on all models or on all cycles. Done This will indicate that the selected cycle has ended and the load may be removed from the dryer. If Wrinkle Prevent has been selected, the dryer may continue to tumble the load, even if the Done indicator is lit. Check Lint Screen The Check Lint Screen indicator light will flash as a reminder to clean the lint screen. It will flash until the door is opened or a cycle is started. It will turn off when the dryer is turned off. 6