Memorex Mi2032 User Guide - Page 6
Power Source - specs
UPC - 749720012138
View all Memorex Mi2032 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
POWER SOURCE AC CONNECTION Insert the small end of the AC adapter into the DC IN 15V jack (located on the rear of the unit). Connect the other end to a wall outlet having 120V AC, 60 Hz. AC Adapter, DC 15V Z NOTES: • Remove both the DC plug and the AC- IN plug to disconnect the AC adapter when not in use. To DC 5V IN Jack • Only use the supplied AC adapter which has the following specs: DC 15V Z REMOTE BATTERY INSTALLATION 1. Remove the Battery Compartment by pressing in on the tab and then sliding the compartment out. 2. Install a CR2025 battery, paying attention to the polarity diagram in the Battery Compartment (positive side up). 3. Replace the Battery Compartment. BATTERY PRECAUTIONS Follow these precautions when using a battery in this device: 1. Warning-Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type. 2. Use only the size and type of battery specified. 3. Be sure to follow the correct polarity when installing the battery as indicated next to the battery compartment. A reversed battery may cause damage to the device. 4. If the device is not to be used for a long period of time, remove the battery to prevent damage or injury from possible battery leakage. 5. Do not try to recharge a battery not intended to be recharged; it can overheat and rupture. (Follow battery manufacturer's directions.) 5