NEC 1940WCXM LCD195WVXM_1940WCXM Users Manual - Page 14

Specifications Monitor Specifications MultiSync LCD195WVXM 1940WCXM Notes LCD Module Diagonal: 19.0 inch Active matrix; thin film transistor (TFT) Viewable Image Size: 19.0 inch liquid crystal display (LCD); 0.284 mm dot Native Resolution (Pixel Count): 1440 x 900 pitch; 300cd/m2 white luminence; 700:1 contrast ratio, typical Input Signal PC INPUT Video: ANALOG 0.7 Vp-p/75 Ohms Digital Input: DVI Sync: Separate sync TTL Level (Positive/Negative) Horizontal sync Positive/Negative Vertical sync Positive/Negative AUDIO INPUT STEREO Mini Jack 500mV rms Input Impedance 14 Kohm Head Phone Output STEREO Mini Jack Headphone Impedance 32 Ohm Display Colors Analog input: 16.2M Depending on display card used. Maximum Horizontal: 170° (CR>5) Viewing Angles Vertical: 160° (CR>5) Synchronization Horizontal: 31.5 kHz to 81.1 kHz Automatically Range Vertical: 56 Hz to 76 Hz Automatically Resolutions Supported 720 x 400*1 : VGA text Some systems may not support 640 x 480*1 at 60 Hz to 75 Hz all modes listed. 800 x 600*1 at 56 Hz to 75 Hz 832 x 624*1 at 75 Hz 1024 x 768*1 at 60 Hz to 76 Hz 1280 x 768*1 at 60 Hz 1152 x 864*1 at 60 Hz to 75 Hz 1152 x 870*1 at 75 Hz 1280 x 960*1 at 60 Hz to 75 Hz 1280 x 1024 at 60 Hz to 76 Hz NEC DISPLAY SOLUTIONS cites 1360 x 768 at 60 Hz recommended resolution at 60 Hz for 1440 x 900 at 60 Hz to 75 Hz optimal display performance. Active Display Area Horizontal : 408.2 mm/16.1 inches Vertical : 255.2 mm/10.0 inches Power Supply 100-240 V ~ 50/60 Hz Current Rating 0.65-0.3A/100-240V Speakers Practical Audio Output: 1+1 watts Dimensions 440.0 mm (W) x 361.0 mm (H) x 210.0 mm (D) 17.3 inches (W) x 14.2 inches (H) x 8.3 inches (D) Weight 4.6 kg 10.1 lbs Environmental Considerations Operating Temperature: 5°C to 35°C/41°F to 95°F Humidity: 10% to 80% Altitude: 0 to 10,000 Feet Storage Temperature: -10°C to +60°C/14°F to 140°F Humidity: 10% to 85% Altitude: 0 to 40,000 Feet *1 Interpolated Resolutions: When resolutions are shown that are lower than the pixel count of the LCD module, text may appear different. This is normal and necessary for all current flat panel technologies when displaying non-native resolutions full screen. In flat panel technologies, each dot on the screen is actually one pixel, so to expand resolutions to full screen, an interpolation of the resolution must be done. NOTE: Technical specifications are subject to change without notice. 12