NEC 8M-B80AX1U 8M-B80AX1U Operation Manual - Page 141
Setting the Monitor on the Wall
View all NEC 8M-B80AX1U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 141 highlights
2/28/2019 Contents 1. Part Names 2. Basic Operation 3. Menu Operation 4. USB Media 5. AQUOS LINK and Other Devices 6. Operating the Monitor Using a PC (IP control) 7. Troubleshooting 8. Specifications, etc. You can select an OSD language from among 8 languages. English (UK) >> Français >> Deutsch >> Italiano Español >> Polski >> English (US) >> Ver. 1.01 > Specifications, etc. < Setting the Monitor on the Wall Sharp operation manual For the screws, refer to the table shown below. Unit: mm Standard screws M8 (Use 1.25 pitch screws.) Length(Depth of mounting holes) 12 Quantity 4 pcs. NOTE To use this Monitor mounted on a wall, remove the cable tie as needed. Do not use screws that do not comply with the VESA standard screw specifications. Do not use screws that are longer than the standard length. Screws that are too long may cause damage to the inside of the Monitor. Do not fasten the screws too firmly or loosely. This may damage the product or cause the product to fall, leading to personal injury. SHARP is not liable for these kinds of accidents. SHARP is not liable for product damage or personal injury when a non-VESA or non-specified wall mount is used or the consumer fails to follow the product installation instructions. Do not install the wall mount kit while your Monitor is turned on. It may result in personal injury due to electric shock. 8-5