NEC AS224WMi-BK User Manual - Page 10
Remove the Base Stand, Connect a Flexible Arm, Specifications
View all NEC AS224WMi-BK manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Remove the Base Stand NOTE: Always remove the Base Stand when shipping the LCD. 1. Place monitor face down on a non-abrasive surface (Figure R.1). 2. Using your thumb, press the button to unlock (Figure R.4). 3. With the button pressed in, pull off the Base Stand (Figure R.4). Connect a Flexible Arm This LCD monitor is designed for use with a flexible arm. Figure R.4 Please use screws (4pcs) as shown in the picture when installing. To meet the safety requirements, the monitor must be mounted to an arm which, guaranties the necessary stability under consideration of the weight of the monitor. Caution: Use ONLY the screws (4 pcs) that were removed from the stand or the specified screws (Figure F.1) to avoid damage to the monitor or stand. To meet the safety requirements, the monitor must be mounted to an arm which guaranties the necessary stability under consideration of the weight of the monitor. The LCD monitor should only be used with an approved arm (e.g. TUEV GS mark). NOTE: Tighten all screws (recommended Fasten Force: 98 - 137 N•cm). 12 mm M4 4 x 12 mm with lock washer and flat washer Thickness of Bracket (Arm) 2.0 ~ 3.2 mm 100 mm Tighten all screws Specifications 4-SCREWS (M4) (MAX depth: 10 mm) If use other screw, check depth of hole. 100 mm Figure F.1 Weight of LCD assembly: 3.7 kg (MAX) English-8