NEC HT510 HT510 IG - Page 7

Input Panel PC CONTROL COMPUTER IN Y Cb/Pb S-VIDEO IN AUDIO IN Cr/Pr COMPONENT IN VIDEO IN L R AUDIO IN Control Codes FUNCTION POWER ON POWER OFF INPUT SELECT COMPUTER INPUT SELECT COMPONENT INPUT SELECT VIDEO INPUT SELECT S-VIDEO PICTURE MUTE ON PICTURE MUTE OFF SOUND MUTE ON SOUND MUTE OFF CODE DATA 02H 00H 00H 00H 00H 02H 02H 01H 00H 00H 00H 03H 02H 03H 00H 00H 02H 01H 01H 09H 02H 03H 00H 00H 02H 01H 11H 19H 02H 03H 00H 00H 02H 01H 06H 0EH 02H 03H 00H 00H 02H 01H 0BH 13H 02H 10H 00H 00H 00H 12H 02H 11H 00H 00H 00H 13H 02H 12H 00H 00H 00H 14H 02H 13H 00H 00H 00H 15H Note: Checksum (CKS) is already included in the commands above. Note: Contact your NEC rep for codes not listed. Cable Connection Communication Protocol: Baud Rate: 38400 bps Data Length: 8 bits Parity: No Parity Stop Bit: One bit X on/off: None Communications: Full duplex PC Control Connector (DIN-8P) To RxD of PC 8 76 5 4 3 21 To GND of PC To TxD of PC NOTE 1: It is recommended to set the projector to "Idle Mode" in the Setup menu for best Power ON response. NOTE 2: Pins 2, 3, 5, 6 and 8 are used inside the projector. NOTE 3: For long cable runs it is recommended to set communication speed within projector menus to 9600 bps. Digital Light Processing, DLP, Digital Micromirror Device and DMD are trademarks of Texas Instruments. www.necvisualsystems.com HT510 Page 7 of 7